An added benefit from kinetic reading is that the signal-to-backg

An added benefit from kinetic reading is that the signal-to-background computed from kinetic measurements can be over 100 fold enabling screening under conditions of low substrate conversion. In contrast, a quenched reaction occurs by running many small scale reactions and stopping these at various times by adding a reagent that inhibits the enzyme without destroying the product that has been formed. Quenched reactions are carried out when it is not possible to detect changes in the system (e.g., product formation) during the course of the reaction without interfering with the reaction.

For instance, many products such as inorganic phosphate or metabolic intermediates cannot be visualized via spectrophotometric methods in a continuous mode. Therefore, the reaction must be stopped and the products observed by another method, either by indirect detection using Selleck BMS 354825 a reagent or a coupling enzyme (see below) or using analytical techniques such

as radiography or mass spectrometry. Quenched reactions lend themselves to high throughput methods because many reactions can be run simultaneously and stopped, allowing detection to at a specific reaction time, typically Selleck Afatinib chosen based on kinetic data and the percent conversion of product. However, collecting kinetic data by performing multiple quenched reactions typically leads to more variable data than continuous modes of detection because of the increased reagent transfer steps inherent to quenched reactions leading to more variation

between samples. In addition, the time points taken are limited by the liquid handling capabilities and the physical constraints that dictate the time of detection between two quenched reactions. Often, the product of a reaction is difficult Glutamate dehydrogenase to detect directly either due to properties such as size, stability or solubility of the molecule, or because the product is spectroscopically silent using current direct detection technologies. In this case, a coupled or indirect measurement is needed to follow the progress of a reaction. Consider a typical GTPase enzyme involved in cell signaling. The substrate (GTP) and products (GDP and Pi) are quite small, making them difficult to separate/quantitate via liquid chromatography mass spectrometry (LC/MS). Additionally, neither molecule is conducive to spectrophotometric detection techniques, and short of using radioactive isotopes, direct detection of products is nontrivial. Therefore, an indirect detection system is useful. In this case, a fluorescently labeled phosphate binding protein (PBP) binds to Pi with an extremely high affinity, which results in an increase in fluorescence of the protein. The signal observed is due to PBP binding to Pi, not from Pi itself, but by coupling the PBP within the reaction ( Lavery et al., 2001). Another method to detect Pi product formation in an indirect manner uses malachite green and the inherent fluorescence of white microtiter plates ( Zuck et al., 2005).

Leave a Reply

Your email address will not be published. Required fields are marked *

*

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <strike> <strong>